Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID841
    KitDescCoin and Card
    componentMounting

    Apply C-5035 Labelover the coin drop opening.Place theC-6700-TEMPDrill Template on the desired mounting location.
  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
    cci-readerinstall-kit
    KitID966
    KitDescCard Only

    ...

    step
    componentPower

    Tap power as described in the document using theC-5101 Spade Taps provided.Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kitstep
    KitID595

    ...

    componentCoin Sense

    cci-readerinstall-kitstep
    KitID722
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6368 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    componentStart

    cci-readerinstall-kit
    KitID653
    KitDescPulse
    1. Connect the C-5345 Machine Start Harness to the Coin 1 connection on the Machine Control Assembly.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the F2,F3 Reader Install Guide.
    2. Connect the free end of the C-5345 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6368 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    step
    componentReader

    Cci readerinstall footer