Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Place theC-6700-TEMPDrill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card
    componentMounting

  • Remove existing coin box and coin mechanism.

  • Run reader harnesses through the metercase and out the opening where the coin mechanism was mounted.

    • Attach the C-5414 Reader Bracketto the C-6911 Metercase Bracketusing(2)C-542010-32 x 1/4 Pan Screws.Insert the reader harnesses through the hole in the C-6911 Metercase Bracketand then insert the bracket into the metercase opening.Secure the C-6911 Metercase Bracket to the metercase using the C-0301Mounting Bolt.
    cci-readerinstall-kit
    KitID598
    KitDescCard Only - Coin Model

    ...

    step
    componentPower

    Use the C-5101 Spade Tapson the incoming power.Tap theL1wire.Tap theNwire.Tap theGround wire.Take the C-5210 Power Adapter Harnessand connect the red tab connectors to the following wires:Connect thebluewire to theL1wire.Connect thebrownwire to theNwire.Connect the green/yellow wire to theGroundwire.Connect the 3-pin connector from the C-5210 Power Adapter Harnessto the matching connection on the C-5602R1Power Converter.Connect the4-pinconnector from the C-5602R1 Power Converterto the matching connection on the C-5500Power Extension Harness.
    cci-readerinstall-kit
    KitID595
    KitDescTap Machine Power

    ...

    step
    componentCoin Sense

  • Disconnect the Coin Drop from the Machine Control Assembly.
    • Connect theC-6362 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kitstep
    KitIDcomponent721
    KitDescCoin Drop - Factory Optical

    Connect Machine Interface Harness

    Start

    Cci readerinstall kit
    KitID665
    KitDescPulse - Coin Connection

    1. Connect the C-5371 Machine Start Harness to the P10 (Coin 1) connector on the Machine Control Assembly.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Cci readerinstall step
    componentReader

    Cci readerinstall footer