Page Comparison

...

This section walks you through adding your equipment mix into the X-Changer. You will need to have a computer or other another device to access our installation guides which will tell you what equipment type to choose as well as other settings for the equipment type.

1. Plug in mouse and keyboard to computer.
2. Insert the Managers Card
3. Choose System Setup.
   
4. Choose Card Reader Setup.
   

5. The system will give you a warning. Click on Continue. All readers will be shut down. This may take up to 60 seconds.
   Image Modified

   
   

6. Click Add New Equip Type

   Image Removed
   

On the Add New Equipment Type page, you will be presented with several fields to complete.  

You must click Save and Next after each Equipment Type has been entered or it will not save the setup previously entered.

Image Removed

FieldsDescriptionsControl

The Control type of the equipment you are installing (Found in the Installation Guides Website).

Equipment NameThe name of the equipment. (Example: EH020 Washer).Equipment Type

The type of equipment you are installing. If an MLV control is chosen, the system will automatically fill this in. If a Single-Vend option is chosen, you will need to change the number to the correct one for the equipment type.

Image Removed

Free Dry Awards

This is the number of free dries a customer will receive from the washer if the option in requested by the Owner.

Vend Price $This should be filled out with a generic price. The actual price will be added later.Bonus Allowed

If the Owner is going to allow bonus money to be used to start the machine, this option should be checked.

Discount Allowed

If the Owner is going to allow discounts to be used to start the machine, this option should be checked.

Start Hours

This is the hour start of when the machine will be usable

End Hours

This is when the machine will be disabled. Usually ½ hour before the store closes.

Cycle Time (sec)This is set if Single-Vend is chosen for the equipment type. This is the total cycle time of the machine that will lock out the reader during the cycle.Pulse Length (ms)This is set if Single-Vend is chosen for the equipment type. This is the pulse rate and the installation guide should be consulted for the correct setting.

Door Sensor

For single vend only machines, when selected, the reader will check if there's a door sensor and will NOT allow a start if door is open.

7. Enter all the equipment types that are in the store including any vending and doors. You only need to enter the equipment once for each type of machine.

8. Click the Back button when finished entering all machines.

9. Click the Machine Config Button.

   Image Removed

10. This is the Machine Overview Page. This page sets the equipment to the correct machine number and the correct Line the machine is on.

    Image Removed

11. Click on the first machine.

12. Complete the fields on this page:
    Image Removed

...

Click the Back Button.

Click Done.

Your equipment should be ready to start. At this time if the information was entered correctly the readers will start to download the appropriate firmware. This may take some time.

...