Install Mounting Hardware
| cci-readerinstall-kitstep |
|---|
| KitID | 841 |
|---|
| KitDesc | Coin and Card Install |
|---|
|
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to FasCard F2/F3 Reader Installation Guide - Front Mount for further instructions.| Cci readerinstall kit |
|---|
| KitID | 959 |
|---|
| KitDesc | Card Only Install - Coin Model |
|---|
|
Remove existing coin drop.
Install C-0913 Drop Cover where the coin drop was previously mounted. Secure using (4) C-1062 4-40 Keps Nuts.
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify that included harnesses will reach the desired location without encountering interference from internal machine components.
Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.Optional: Use C-5710 Rubber Grommet to protect harnesses from damage during machine operation if any secondary hole is cut internally to run harnesses to the reader mounting location.
...
| cci-readerinstall-kit |
|---|
|
Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
...
| cci-readerinstall-kit |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-6343 Coin Sense Harness to the harness connected to the Coin Drop.| step |
|---|
|
|
| cci-readerinstall-kitstep |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6368 Coin Sense Harness to the harness connected to the Coin Drop.
|
...
| cci-readerinstall-kit |
|---|
|
Connect the C-5345 Machine Start Harness to the coin 1 connector on the Machine Control Assembly.
|
Connect and Mount Reader
...
Feed remaining harness ends through the mounting hole as described in the FasCard F2/F3 Reader Installation Guide - Front Mount.
...
Connect the free end of the Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
...
Connect the free end of the Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
...
Connect the free end of the C-5500-60 Power Harness to port 1.
...
Machine Configuration
None required.
...