Install Mounting Hardware
| cci-readerinstall-kit |
|---|
| KitID | 841 |
|---|
| KitDesc | Coin and Card |
|---|
|
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.
...
| cci-readerinstall-kitstep |
|---|
|
Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5211 Power Adapter Harness to the power distribution panel inside the machine.120vac: Connect the brown and blue wires to connector |
|
120vac: Use connectors #2 closest to outside of machine and #4 on terminal side closest to circuit board.
240vac:
...
Use connectors #3 and #5 on the terminal side closest to the circuit board.
...
Secure the green wire beneath the ground screw.
...
Connect the opposite end of the C-5211 Power Adapter Harness to the C-5602 Power Converter.
...
Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
...
| cci-readerinstall-kitstep |
|---|
| KitID | 704 |
|---|
| KitDesc | Coin Drop: Factory |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6253 Coin Sense Harness to the microswitch on to the Coin Drop.
|
Connect Machine Interface Harness
| cci-readerinstall-kitstep |
|---|
|
Connect the C-5254 Machine Start Harness to the P2 connector on the Machine Control Assembly.
|
...