| cci-readerinstall-kit |
|---|
| KitID | 584 |
|---|
| KitDesc | Coin and Card |
|---|
|
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to FasCard Mounting Guide for further instructions.| step |
|---|
|
|
| cci-readerinstall-kit |
|---|
| KitID | 845 |
|---|
| KitDesc | Card Only - 30lb or Larger Model |
|---|
|
Remove existing coin box and coin drop.
Secure C-5414 F2 Mounting Bracket to the C-6903 Mounting Bracket using the (2)C-5420 10-32 x 1/4 Pan Screws.Install the C-6903Mounting Bracket into the Coin Vault. Use (4) C-1042Kep Nuts to secure to Coin Vault.
...
| cci-readerinstall-kit |
|---|
| KitID | 663 |
|---|
| KitDesc | Tap 120/240v Power |
|---|
|
Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.Connect the C-5336 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
Secure the ground wire beneath a chassis screw.
Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
...
| Cci readerinstall kit |
|---|
|
Connect the C-0114-MLV Machine Start Harness to the middle X1 port on the serial communication board.
The RJ11 connector on the end of the C-0114-MLV Machine Start Harness will fit into the middle X1 RJ45 port even though the RJ11 connectoris smaller in size.CCIDOCCOM Boardsfalse| Cci readerinstall kit |
|---|
| KitID | 885 |
|---|
| KitDesc | Pulse - Combination Harness - Machine Interface Connections |
|---|
|
Connect the red, female, 8-pin connector of the C-6330 Combination Harness to the Coin Acceptor connector on the Machine Control Assembly.| step |
|---|
|
|
...