Versions Compared

Old Version 4

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card
    componentMounting

  • Remove existing coin box and coin mechanism.

  • Run reader harnesses through the metercase and out the opening where the coin mechanism was mounted.

    • Attach the C-5414 Reader Bracket to the C-6911 Metercase Bracket using (2)C-5420 10-32 x 1/4 Pan Screws.

  • Insert the reader harnesses through the hole in the C-6911 Metercase Bracket and then insert the bracket into the metercase opening.

  • Secure the C-6911 Metercase Bracket to the metercase using the C-0301 Mounting Bolt.

    • cci-readerinstall-kit
    KitID598
    KitDescCard Only - Coin Model

    ...

    step
    componentPower

    cci-readerinstall-kit
    KitID595
    KitDescTap Machine Power

    1. Use the C-5101 Spade Taps on the incoming power.

      1. Tap the L1 wire.

      2. Tap the N wire.

      3. Tap the Ground wire.

    2. Take the C-5210 Power Adapter Harness and connect the red tab connectors to the following wires:

      1. Connect the blue wire to the L1 wire.

      2. Connect the brown wire to the N wire.

      3. Connect the green/yellow wire to the Ground wire.

    3. Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connection on the C-5602R1 Power Converter.

    4. Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connection on the C-5500 Power Extension Harness.

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitIDcomponent721
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6362 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Feed remaining harness ends through the mounting hole.

    ...

    Connect the free end of the C-5364 Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.

    ...

    (Coin and Card Installations Only) Connect the free end of the C-6362 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.

    ...

    Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.

    ...

    Start

    Cci readerinstall step
    componentReader

    Machine Configuration

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameMayTag Gen1 MLV+ Pulse
    PageWithExcerpt_Machine Configuration

    ...