Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    step
    componentMounting

  • Remove existing coin drop.

  • Install C-0913 Drop Cover where the coin drop was previously installed. Secure in place with C-1062 Kep Nuts.

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID959
    KitDescCard Only

    ...

    step
    componentPower

  • Tap the machine AC power wires using the C-5101 Spade Taps.

    1. For 120v models: L1, N, and Ground wires

    2. For 240v models: L1, L2, and Ground wires

  • Connect the three wires from the C-5210 Power Adapter Harness to theC-5101 Spade Taps.
    1. Connect the Blue wire to the L1 tap.

    2. Connect the Brown wire to the N/L2 tap.

    3. Connect the Green/Yellow wire to the Ground tap.

  • Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connector on the C-5602R1 Power Converter.

  • Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500-60 Power Extension Harness.

  • Run the C-5500-60 Power Extension Harness to the reader mounting location.

  • cci-readerinstall-kit
    KitID802
    KitDescTap Machine Source Power

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitIDcomponent722Start
    KitDescFactory - Optical Coin Drop
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6368 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    ...

    Cci readerinstall step
    componentReader

    Cci readerinstall footer