Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Remove existing coin box and coin drop.

  • Install the C-0913 Drop Cover in the coin drop opening and secure using the C-1062 Keps Nuts.

  • Run all reader harnesses through coin vault and then the hole of the C-6936 Vault Bracket.

  • Bend the side tabs of the C-6936 Vault Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

  • Run all reader harnesses through the central hole of the C-5414 Reader Bracket.

  • Attach the C-5414 Reader Bracket to the C-6936 Vault Bracketusing the C-0144 screw so that it is flush with the front panel.
    cci-readerinstall-kitstep
    KitIDcomponent940
    KitDescCard Only - Coin Model

    ...

    Mounting

    Cci readerinstall step
    componentPower

    cci-readerinstall-kit
    KitID595
    KitDescTap Machine Power
    1. Use the C-5101 Spade Taps on the incoming power.

      1. Tap the L1 wire.

      2. Tap the N / L2 wire.

      3. Tap the Ground wire.

    2. Take the C-5210 Power Adapter Harness and connect the red tab connectors to the following wires:

      1. Connect the blue wire to the L1 wire.

      2. Connect the brown wire to the N / L2 wire.

      3. Connect the green/yellow wire to the Ground wire.

    3. Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connection on the C-5602R1 Power Converter.

    4. Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connection on the C-5500 Power Extension Harness.

    ...

    step
    componentCoin Sense

    Cci readerinstall step
    componentStart

    ...