Versions Compared

Old Version 4

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to F2 FasCard Reader Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    step
    componentMounting

  • Install the C-6970 Alliance Mounting Bracket into the opening on the control panel for mounting card readers and coin drops.

    • Attach the C-5414 F2 Mounting Bracketto the C-6970 Alliance Mounting Bracket and secure using the C-1060 Screws.Refer to F2 FasCard Reader Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID865
    KitDescCard Only - Card Ready Models

    ...

    step
    componentPower

    cci-readerinstall-kit
    KitID581

    1. Connect the C-6204-40 Power Adapter Harness (12VDC power) to the H10 connection on the Machine Control Assembly.

      1. Secure the green wire beneath the ground screw.

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID700
    KitDescCoin Drop: Factory

    1. Disconnect the coin drop from the machine control assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the coin drop.

    componentStart

    cci-readerinstall-kitstep
    KitIDcomponent928Reader
    KitDescCoin Drop: Factory - Dual Coin

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 1 Drop.

    3. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 2 Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID582
    KitDescPulse and Serial

    1. Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.

    ...

    componentReader

    Machine Configuration

    ...

    Machine Configuration

    Multiexcerpt include
    SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
    MultiExcerptNameACA Configuration
    PageWithExcerpt_Machine Configuration

    Cci readerinstall footer