Versions Compared

Version Old Version 4 New Version Current
Changes made by

Chris Kite

Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    step
    componentMounting

    cci-readerinstall-kit
    KitID863
    KitDescCard Only

    Coin Ready

    1. Remove existing coin box.

    2. Bend the side tabs of the C-6602 Vault Mount Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

    3. Use the C-0144 Screws, attach the C-5414 F2 Mounting Bracket to the C-6602 Vault Mount Bracket

    ...

    step
    componentPower

    cci-readerinstall-kit
    KitID581

    1. Connect the C-6204-40 12VDC Power Harness to the H10 connection on the machine control assembly.

      1. Secure the green wire beneath the ground screw.

    2. Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) to the F2 reader.

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID700
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Cci readerinstall kit
    KitID928
    KitDescCoin Drop: Factory - Dual Coin

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 1 Drop.

    3. Connect a C-6250 Coin Sense Harness to the harness connected to the Coin 2 Drop.

    Connect Machine Interface Harness

    Connect the C-5300-NC Machine Start Harness to the Machine Control Assembly.
    Cci readerinstall kit
    KitID645
    KitDescPulse
    componentStart

    cci-readerinstall-kitstep
    KitID582
    KitDescSerial

    1. Connect the C-5240 Machine Start Harness to the Machine Control Assembly.

    For Card only

    1. Connect the C-5365 Bypass Harness to the appropriate connections to bypass the coin vault switch. **Needs Better Verbiage)

    ...

    componentExtras

    Cci readerinstall step
    componentReader

    ...