Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kitstep
    KitID584
    KitDescCoin and Card
    componentMounting

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to FasCard Mounting Guide for further instructions.
  • Remove existing coin box and coin drop.

  • Attach C-5760-A Alliance Adapter Bracket to C-6760 Metercase Bracket.

  • Attach the C-5414 Mounting Bracket to C-6760 Metercase Bracket using the (2)C-5420 10-32 x 1/4 Pan Screws.
  • Mount C-6760 Metercase Bracket into the front of the metercase, inserting the two studs through the coin slot openings.

    1. Secure to the metercase using (2) C-1059 Keps Nuts and (2) C-1070-W Washers.

  • cci-readerinstall-kit
    KitID906
    KitDescCard Only - Card Model
    Cci readerinstall kit
    KitID916
    KitDescCard Only - Coin Model w/ Rear Control Panel

    ...

    step
    componentPower

    Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5210 Power Adapter Harness to the power distribution panel inside the machine.
    1. 120vac: Connect the blue wire to L1 and the brown wire to N.

    2. 240vac: Connect the blue wire to L1 and the brown wire to L2.

    3. Secure the green wire to the ground wire.

  • Connect the opposite end of the C-5210 Power Adapter Harness to the C-5602R1 Power Converter.

  • Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602R1 Power Converter. The remaining cable end connects to the FasCard reader.

  • cci-readerinstall-kit
    KitID595
    KitDescTap 120v Machine Power

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID700
    KitDescCoin Drop - Optical
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    componentStart

    Connect the C-0110-TOP Machine Start Harness to the machine control assemblyat:
    1. H5 for MDC controls.

    2. H4 for Centurion controls.

  • (Serial Communication Setup Only) Replace the existing Alliance Jumper Plug with C-0110-CP Jumper Plug at:

    1. H2 for MDC controls.

    2. H6 for Centurion controls

  • cci-readerinstall-kit
    KitID603
    KitDescSerial / Pulse - MDC & Centurion Control

    ...

    step
    componentReader

    Machine Configuration

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameMDC Configuration (TLW / FLW)
    PageWithExcerpt_Machine Configuration

    ...