Install Mounting Hardware
| cci-readerinstall-kitstep |
|---|
| KitIDcomponent | 584 |
|---|
| KitDesc | Coin and Card |
|---|
| Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.
...
| cci-readerinstall-kitstep |
|---|
| Connect the C-6204-40 Power Adapter Harness to the H10 connection on the machine control board.
Secure the green wire beneath the ground screw.
Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) into the back of the F1 Reader.
...
| cci-readerinstall-kitstep |
|---|
| Cci readerinstall kit |
|---|
| KitID | 582 |
|---|
| KitDesc | Serial or Pulse |
|---|
|
Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.
| Cci readerinstall step |
|---|
| KitIDcomponent | 700 |
|---|
| KitDesc | Coin Drop: Factory |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.
|
Connect Machine Interface Harness
Machine Configuration
| Multiexcerpt include |
|---|
| SpaceWithExcerpt | com.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f |
|---|
| MultiExcerptName | Midas |
|---|
| PageWithExcerpt | _Machine Configuration |
|---|
|