Install Mounting Hardware
Connect Power
...
| Cci readerinstall kit |
|---|
| KitID | 884 |
|---|
| KitDesc | Factory - Optical Coin Drop - Coin Sense Portion of Combination Harness |
|---|
|
Disconnect the coin sensor from Terminal Board C. Connect the wires from the coin sensor to the three circuit screw down terminal with the blue, green, and red wires. Pair the harness wires to the same colored wires from the coin sensor.
Disconnect the wires from the door switch and connect the white wires with female spade terminal connectors to the same locations.
|
...
| Cci readerinstall kit |
|---|
| KitID | 884 |
|---|
| KitDesc | Factory - Optical Coin Drop - Start Pulse Portion of Combination Harness |
|---|
|
Connect the wires from the Terminal Board C to the three circuit screw down terminal with the blue, green, and black wires. Pair the machine wires to the the following screw down terminal wires: Blue wire to blue. Green wire to green. Red wire to black.
Take the wires previously connected to the door switch and connect the white wires with male spade terminal connectors to the wires.
|
Connect and Mount Reader
| Multiexcerpt include |
|---|
| SpaceWithExcerpt | CCIDOC |
|---|
| MultiExcerptName | F2 Reader |
|---|
| PageWithExcerpt | _Reader Ports |
|---|
|
...
Feed remaining harness ends through the mounting hole.
...
Connect the larger, white 6-pin connector of the C-6310 Combination Harness to port 2 (Pulse Connection Port) as shown in the image above.
...
(Coin and Card Installation Only) Connect the smaller, white 5-pin connector of the C-6310 Combination Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
...