| cci-readerinstall-kit |
|---|
| KitID | 813 |
|---|
| KitDesc | Card Only - Coin Model |
|---|
|
Remove coin drop and coin box.
Insert the C-5771 Metercase Bracket over the front of the metercase. Attach using the C-0303 Topload Mounting Bolt from the inside of the metercase.
Optional: Apply the C-5027 Label on or near the card reader for any accepted credit card issuers. | step |
|---|
|
|
| cci-readerinstall-kit |
|---|
|
Remove existing coin box and coin drop. Insert C-0911 Metercase Bracket into the metercase and secure using the C-0301 Topload Mounting Bolt. Attach reader to C-0911 Metercase Bracket using C-0141 Screws once all harnesses are connected. Cover mounting screw holes using C-0015 Cover Label.
|
| Cci readerinstall kit |
|---|
| KitID | 584 |
|---|
| KitDesc | Coin and Card |
|---|
|
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to FasCard Mounting Guide for further instructions.| Cci readerinstall kit |
|---|
| KitID | 906 |
|---|
| KitDesc | Card Only - Card Ready Models |
|---|
|
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to FasCard Mounting Guide for further instructions.| Cci readerinstall kit |
|---|
| KitID | 860 |
|---|
| KitDesc | Card Only - Coin Ready Models |
|---|
|
Remove existing coin box and coin drop.
Run reader harnesses through the metercase and out the opening where the coin mechanism was mounted.
Attach the C-5414 Reader Bracket to the C-6911 Metercase Bracket using (2)C-5420 10-32 x 1/4 Pan Screws.Run reader harnesses through the circular opening in the C-6911 Metercase Bracket.
Insert C-6911 Metercase Bracket into the metercase and secure using the C-0303 Topload Mounting Bolt.
...
| cci-readerinstall-kit |
|---|
|
Tap the incoming AC power wires using the C-5101 Spade Taps.
For 120v models: L1, N, and Ground wires
Connect the three wires from the C-5210 Power Adapter Harness to theC-5101 Spade Taps.Connect the Blue wire to the L1 tap.
Connect the Brown wire to the N tap.
Connect the Green/Yellow wire to the Ground tap.
Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connector on the C-5602R1 Power Converter.
Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500 Power Extension Harness.
Run the C-5500 Power Extension Harness to the reader mounting location.
...
...
...