Versions Compared

Old Version 5

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Remove existing coin box and coin drop.

  • Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.

  • Attach the C-5414 F2 Mounting Bracket to the C-6765-W-R1 Metercase Bracket using (2) C-5420 10-32 x 1/4 Pan Screws.

    • Run any card reader harnesses through the coin slot openings and the circular hole in the C-6765-W-R1Metercase Bracket.

  • Install the C-6765-W-R1 Metercase Bracket so that the two threaded posts insert into the coin drop slots. Then secure it to the machine using the (2) C-1059 Kep Nuts and (2) C-1070-W Washers.

    • cci-readerinstall-kit
    KitID857
    KitDescCard Only - White 10° Panel Coin Models

    Connect Power

    step
    componentMounting

    cci-readerinstall-kit
    KitID581
    KitDescACA Controls - 12VDC Accessory Power

    1. Connect the C-6204-40 12VDC Power Harness to the H10 connection on the machine control assembly.

      1. Secure the green wire beneath the ground screw.

    2. Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) to the F2 reader.

    Cci readerinstall kit
    KitID837
    KitDescTitanium Controls - 24VAC Transformer

    1. Connect the 2-pin connector from the C-6207 F2, ACA Power Harness to the 24v transformer behind the front control panel.

    2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

    Connect Coin Sense Harness

    step
    componentPower

  • Disconnect the Coin Drop from the Machine Control Assembly.

    • Connect the C-6250 Coin Sense Harness to the Coin 1 machine harness connected to the coin drop.
    cci-readerinstall-kit
    KitID700
    KitDescCoin Drop - Factory Optical
    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitIDcomponent928
    KitDescCoin Drop - Factory Dual Optical

    1. Disconnect both of the Coin Drops from the Machine Control Assembly.

    2. Connect one of the C-6250 Coin Sense Harness to the Coin 1 machine harness and the other to the Coin 2 machine harness.

    Connect Machine Interface Harness

    Start

    cci-readerinstall-kit
    KitID582
    KitDescSerial Communication / Serial Pulse

    1. Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.

    ...

    step
    componentReader

    Machine Configuration

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameACA Configuration
    PageWithExcerpt_Machine Configuration

    ...