Install Mounting Hardware
| cci-readerinstall-kit |
|---|
| KitID | 841 |
|---|
| KitDesc | Coin and Card |
|---|
|
Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to FasCard Mounting Guide for further instructions.
| Cci readerinstall kit |
|---|
| KitID | 851 |
|---|
| KitDesc | Card Only - Coin Ready |
|---|
|
Remove Coin Box. Disconnect harness connection from the Vault Switch. Connect both ends to the C-5365 Bypass Harness. Spread the C-6936 Vault Mount Bracket wings to lock it into place once installed. Insert the C-6936 Vault Mount Bracket into the Coin Vault. Use the C-0144 screws, attach the C-5414 F2 Mounting Bracket to the C-6936 Vault Mount Bracket.
|
| Cci readerinstall kit |
|---|
| KitID | 846 |
|---|
| KitDesc | Card Only - Card Ready |
|---|
|
Install the C-6970R1 Alliance Mounting Bracket into the opening on the control panel for mounting card readers and coin drops.
Attach the C-5414 F2 Mounting Bracket to the C-6970 Alliance Mounting Bracket and secure using the C-1060 Screws.| step |
|---|
|
|
...
| cci-readerinstall-kit |
|---|
| KitID | 700 |
|---|
| KitDesc | Coin Drop: Factory |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.
|
...
| cci-readerinstall-kitstep |
|---|
|
Connect the C-5300-NC Machine Start Harness to the Coin 1 connector on the Machine Control Assembly. |
|
| cci-readerinstall-kitstep |
|---|
|
Connect the C-0110-TOP Machine Start Harness to the H3 connector on the Machine Control Assembly. |
|
Connect and Mount Reader
| Multiexcerpt include |
|---|
| SpaceWithExcerpt | CCIDOC |
|---|
| MultiExcerptName | F2 Reader |
|---|
| PageWithExcerpt | _Reader Ports |
|---|
|
...
Feed remaining harness ends through the mounting holes.
...
(Standard Installations - No Stack Add-On Kit) Connect the free end of the Machine Start Harness:
If following steps for a serial, connect the C-0110-TOP Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
If following steps for a pulse, connect the C-5300-NC Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
...
(F2/F3 - Serial Stack Add-On Installations Only) Connect the black, 10-pin connector from the C-0110-TOP Machine Start Harness to the Unit 1 connection and the C-0110-TOP Machine Start Harness to the Unit 2 connection on the C-6401 or C-6411 Serial Stack Add-On Board.
...
(Coin and Card Installations Only) Connect the free end of the C-6250 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
...
...
...