Versions Compared

Old Version 5

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card

    ...

    step
    componentMounting

    Connect the C-6204-40 Power Adapter Harness to the H10 connection on the machine control board.

  • Secure the green wire beneath the ground screw.

  • Connect the opposite end of the C-6204-40 Power Adapter Harness (3-pin molex) into the back of the F1 Reader.

    • cci-readerinstall-kitstep
    KitID581

    Connect Coin Sense Harness

    componentPower

    cci-readerinstall-kit
    KitID700
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    step
    componentCoin Sense

    Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.
    cci-readerinstall-kitstep
    KitID582
    KitDescSerial or Pulse
    componentStart

    Cci readerinstall step
    componentReader

    ...