Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card

    Connect Power

    step
    componentMounting

    Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5338 Power Adapter Harness to the power distribution panel inside the machine.
    1. 120vac: Connect the brown and blue wires to connector #2 closest to outside of machine and #4 on terminal side closest to circuit board.

    2. 240vac: Connect the brown and blue wires to connectors 3 and 5 on the terminal side closest to the circuit board.

    3. Secure the green wire beneath the ground screw.

  • Connect the opposite end of the C-5338 Power Adapter Harness to the C-5602 Power Converter.

  • Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

  • cci-readerinstall-kitstep
    KitID473

    Connect Coin Sense Harness

    componentPower

  • Disconnect the Coin Drop from the Machine Control Assembly.

  • Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kitstep
    KitID704
    KitDescCoin Drop: Factory - Micro Switch
    componentCoin Sense

    cci-readerinstall-kit
    KitID707
    KitDescCoin Drop: Factory - Optical Sensor
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6258 Coin Sense Harness to the harness connected to the Coin Drop.

    Cci readerinstall kit
    KitID723
    KitDescCoin Drop: Aftermarket - Imonex
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6382 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Connect the C-5254 Machine Start Harness to the P2 connector on the Machine Control Assembly.
    Cci readerinstall kit
    KitID634
    KitDescPulse
    step
    componentStart

    Cci readerinstall step
    componentReader

    Machine Configuration

    ...

    Cci readerinstall footer