Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to F2 FasCard Reader Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card

    ...

    step
    componentMounting

    cci-readerinstall-kitstep
    KitID581
    1. Connect the C-6204-40 Power Adapter Harness (12VDC power) to the H10 connection on the Machine Control Assembly.

      1. Secure the green wire beneath the ground screw.

    Connect Coin Sense Harness

    componentPower

    cci-readerinstall-kit
    KitID700
    KitDescCoin Drop: Factory
    1. Disconnect the coin drop from the machine control assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the coin drop.

    Connect Machine Interface Harness

    step
    componentCoin Sense

    Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.
    cci-readerinstall-kitstep
    KitID582
    KitDescPulse and Serial
    componentStart

    Cci readerinstall step
    componentReader

    Machine Configuration

    ACA machines using a serial configuration require dip switch 3 on the Machine Control Board to be set to the 'ON' position. Leave all other dip switches as is.

    Multiexcerpt include
    SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
    MultiExcerptNameACA Configuration
    PageWithExcerpt_Machine Configuration

    Cci readerinstall footer