Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card

    Connect Power

    ...

    step
    componentMounting

    cci-readerinstall-kitstep
    KitID704
    KitDescCoin Drop: Factory - Micro Switch
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    componentPower

  • Disconnect the Coin Drop from the Machine Control Assembly.

  • Connect the C-6258 Coin Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kitstep
    KitIDcomponent707KitDescCoin Drop: Factory - Optical Sensor
    Sense

    cci-readerinstall-kitstep
    KitID723
    KitDescCoin Drop: Aftermarket - Imonex
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6382 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Connect the C-5254 Machine Start Harness to the P2 connector on the Machine Control Assembly.
    Cci readerinstall kit
    KitID634
    KitDescPulse
    componentStart

    Cci readerinstall step
    componentReader

    ...