Versions Compared

Old Version 8

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Overview

Card reader programming varies depending upon card reader model.  Select the appropriate tab below, based upon card reader model number.

 

...

Programming Instructions

C-0103 Card Reader

Programming Card Reader Model C-0100

Programming Requirements

  • This programming method requires a C-0100 model card reader as shown above.

Programming Steps

1.

Items Needed

Expand
title
Dip Switch Programming

 

Programming Card Reader Model C-0103(B)

 

Programming Requirements

  • This programming method requires both a CCI Program card and a C-0103 model card reader as shown above.

 

Programming Steps

 

1. Identify desired unit address for card reader.
2. Reboot power to card reader.
3. Insert Program card, reader will display: 

Set Address: 0** 
Dip Card to Set

4. To increase current digit: Insert tip of card and remove quickly.
5. To move to next digit: Insert card fully and wait (approx 2 seconds).
6. After accepting last digit of unit address, reader will display:

Storing Value 
Remove Card Now

 

Card Reader Programming instructions.pdf

 

 

Ui tab
titleC-0101 Card Reader Dip Switch Programming
Bw part list
PartsC-0100,,C-0100-VC
ImageSize100
ShowDesc2true
ShowImagetrue
isMissingRequiredParameterstrue
ShowDesc1true
SingleRowtrue

Programming Steps

  1. Identify desired unit address for card reader.

2. Depress

  1. Set dip switches in combination to equal the unit address value. See below for an explanation of dip switching. Dip Switch Cheat Sheet

    Image Added

Dip Switch

Selection Process

Values

Each switch has a value associated with it, as shown in the table below. Turning switches

on

ON causes their values to be added together.

Switch 1

Switch 2

Switch 3

Switch 4

Switch 5

Switch 6

Switch 7

Switch 8

128

64

32

16

8

4

2

1

 

For example turning switch numbers 8 (1) and 7 (2) on represents the value of 3, or turning on switch numbers 4 (16), 6 (4), and 8 (1) equals 21. Using this binary chart you can achieve any number between 1 and 255.

Once a card reader has been addressed, the reader will display that address across its LCD screen when it is plugged into the system. Once the system recognizes that the reader is online, the reader displays 'Vend Price xxxx'. When the reader is running you can place the reader into a diagnostics mode with the Diag Card, and it will display its programmed address.

The following PDF may be used to help you properly set the switches to represent the desired card reader address. Find the desired reader address in the table and set the switches to the correct associated On/Off settings.

Expand
titleProgram Card Programming

Needed

Bw part list
PartsC-2PROGRAM,C-0101,C-0102,C-0103
ImageSize100
ShowDesc2true
ShowImagetrue
isMissingRequiredParameterstrue
ShowDesc1true
SingleRowtrue

Programming Steps

  1. Identify desired unit address for card reader.

  2. Power cycle card reader.

  3. Insert Program card, reader will display:
    Set Address: 0**
    Dip Card to Set

  4. To increase current digit: Insert tip of card and remove quickly.

  5. To move to next digit: Insert card fully and wait (approx 2 seconds).

  6. After accepting last digit of unit address, reader will display:
    Storing Value
    Remove Card Now

Video Tutorial

Multimedia
nameMVI_0361.MOV