Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

width50%
Panel

...

...

titleTable of Contents
Table of Contents

...

Panel

...

...

title

...

Overview

...

This guide will teach you on how to

...

terminate network/patch cables.

...

Requirements

  • CAT 5 Cable
  • When setting up the wiring

...

  • use the 568-B Wiring Diagram
    Image Modified 

Instructions

  1. Cut the cable to the length that you will need. If you are planning to use boots, this would be a good time to slip them on. Place each boot facing out on the cable.
    Image Modified
  2. Skin the cable about 1.5down. For fast and dependable skinning we recommend our QuickTreX™ EZ Cable stripper.
  3. Remove all of the twists in the cables pairs.
    Image Modified

    Note

    Use a piece of the removed insulation to make it easy to remove the twists from each pair. Un-twist each pair, and straighten each wire between the fingers.

  4. Cat 6 cable has a center spine that needs to be removed. Pull on the spine and fold the pairs back. Then cut the spine as close to the cables end as possible.
    Image Modified
  5. Place the wires in the order.
    Image Modified
  6. Bring all of the wires together, until they touch. Hold the grouped (and sorted) wires together tightly, between the thumb, and the forefinger.
    At this point, recheck the wiring sequence with the diagram.
    Image Modified

  7. Cut the wires on a very sharp angle to make it easier to install the load-bar(in the next step).
    Image Modified
  8. Insert the load bar on the wires one wire at a time. This is why we recommended cutting the wires on an angle. 
    Image Modified
  9. Check the wiring sequence one more time. Than slide the load bar down all the way and make a straight cut about 0.25 past the load bar.
    Image Modified

  10. Insert the connector onto the load bar assembly. Hold the plug with the copper connectors up and the locking clip facing down. 
    Image Modified
    In this configuration, the Brown Pair of wires should be to the right side
    Image Modified 
  11. For Crimping we recommend a Ratchet Crimper for RJ-45 and RJ-11/12.Push the connector all of the way in and then squeeze down all the way on the crimper. Remove the connector from the crimper body.
    Image Modified
  12. Slide the boots (if used) all the way up to the connector. If necessary, use a tapping motion as shown in the illustration.
    Image Modified
  13. Repeat the procedure on the other end of the cable using the same wiring diagram.
  14. Test the cable using a high quality four pair tester.
    Image Modified

Video Tutorial

Widget Connector
urlhttp://www.youtube.com/watch?v=482VtesZwZ8