Versions Compared

Old Version 56

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Mitchell Gralak

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Purpose

The purpose of this document is to guide the New LaundryCard User through the EMV Ingenico Credit Card Reader installation.  These instructions are applicable to V2 X-Changer Cabinets with pre-drilled holes for the Credit Card Reader.

Estimated Installation Time: 30 minutes per cabinet

Table of Contents
maxLevel3

Required Parts

Cci kits
TypeParts
KitIDK-1504-EX1

Prerequisites

Existing LaundryCard System

New acrylic panel installed and mounting holes drilled: Installing The Replacement Acrylic on an Existing Version 2 X-Changer Cabinet Upgrading to EMV

New LaundryCard System

The X-Changer should have arrived with the new acrylic installed and the pre-drilled holes for the Credit Card Bezel.

Installation

  1. Insert the C-1008 Ingenico bezel into the acrylic opening and secure with four C-1011 screws.

  2. Plug the C-1330 USB cable into the USB port on the rear of the Ingenico device.
  3. Route the USB cable to the rear of the Dell computer by weaving around the door harness.
  4. Connect the USB cable to an available USB port on the rear of the Dell computer.
  5. Repeat for all X-Changers.


Warning

The Ingenico device will not work properly until the software is installed and merchant account is set up.  Verify the merchant account is setup with MonetaryDatacap NETePay, and then contact CCI Support at (630) 930-5115 to install the software.