Skip to end of banner
Go to start of banner

Secure Receipt Printer Installation Guide

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 20 Next »

Overview

This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below. This guide further assumes that all relevant Cat5 cables have been run to the point of connection for the LaundryCard reader being installed. Further information regarding cabling and mounting can be found in the LaundryCard Kit Installation Guidelines.

Estimated Installation Time: 30 Minutes


Recommended Tools and Supplies (Not Included): See LaundryCard Kit Installation Home for more information.

Parts List

Kit: K-0664

Kit ID: K-0664
Description: LC Receipt Printer

QTYPart NumberDescriptionImage
1C-0666Thermal Receipt Printer
1C-0667-V2Power Supply
1C-0665Printer cabinet - NP-3511D
1098760Service Lock
1C-13306' USB Cable - Build: XCH
4C-1071Screw
1C-0178UTP Cat5 Cable 25'
1C-0618IOGear USB Print Server

Installation

Step 1 - Install Lock


  1. Disassemble the 098760 Service Lock by removing the nut, kep ring, cam, and mounting nut from the lock.
  2. Push the lock through the opening on the cover of the C-0665 Printer Cabinet and orient so that the inserted key is vertically parallel to the longer sides of the cabinet.
  3. Slide the cam onto the lockshaft with protrusions facing upward.
  4. Slide on the kep ring and secure with the remaining nut.

Step 2 - Mount Printer Cabinet


  1. Determine mounting location (wall or shelf mount) and remove the appropriate knockout.
  2. Mark C-0665 Printer Cabinet cable opening on mounting surface and drill a 1" opening in mounting surface to allow cables to pass through.
  3. Attach printer cabinet to surface with appropriate hardware (not provided).

Step 3 - Install Printer in Printer Cabinet


  1. Pass the C-1330 USB Cable and C-0667 Power Supply cable through the opening and connect the cables to the C-0666 Printer.
  2. Using the slotted holes on the C-0666 Printer, mount the printer to the C-0665 Printer Cabinet. Adjust the printer as far toward the rear of the cabinet as possible.
  3. Load paper into the printer by lifting up on the paper bar.
    1. Lock bar back into place and open feeder release by pulling the Blue lever.
    2. Pull paper across feeder and press down on the feeder assembly until it locks into place.
  4. Close the printer cabinet and turn the key to secure the lock.

Step 4 - Final Connections


  1. Connect the C-0618 Print Server to the C-1330 USB Cable.
  2. Connect the C-0178 Cat5 Cable to the C-0618 Print Server and to the network switch in X-Changer A.
  3. Connect the C-0667 Power Supply to a power outlet.
  4. Connect the C-0618 Print Server power supply to a power outlet.
  • No labels