Skip to end of banner
Go to start of banner

Fascard Touch Kiosk Card Dispenser Additional Maintenance

Skip to end of metadata
  • Created by Former user, last modified by Former user on Oct 22, 2020
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 20 Next »

Overview

This guide provides additional maintenance and troubleshooting steps for the Fascard Touch Kiosk.

Table of Contents

Transport Roller Cleaning



  1. The transport rollers may be cleaned by cycling a cleaning card back and forth between the entry bezel and the card connected position.

  2. Sometimes, when the transport rollers are exceptionally dirty, there is not enough roller grip on the card to move it back and forth.

  3. Insert a cleaning card just far enough for it to be positioned between the front two rollers.
    Allow the rollers to turn for 5 to 10 seconds at which point, increased pull will be felt on the card.

  4. With a firm grip on the cleaning card, insert it still further, until it reaches the rear set of transport rollers.
    Allow all 4 rollers to spin on the card for another 5 to 10 seconds. The card may now be removed, or released and ejected.


Roller Inspection

Inspect the rollers for damage and wear


New Roller


Worn Roller


If the clutch roller does not require replacing, it should be cleaned with Isopropyl Alcohol or a mild detergent and a lint free cloth.

The roller should be rotated by hand, ensuring that all of the surface which makes contact with the card is clean.



Checking Belt Tension

It is critical for the correct operation of the unit, that the two main drivebelts are correctly adjusted.


The drive belts should be visually inspected for damage or wear.
If any of the ‘teeth’ are worn or rounded, the belt should be replaced.  Also verify the orange belts are not loose enough to fall off.

Position Sensors

Ensure the 3 black position sensors are clean.  To clean, wipe the lens surface with a clean dry cloth.




Ensure the 3 white sensor connectors are plugged in properly and fully seated.



Middle Carriage

Please ensure the plastic tabs underneath the middle metal carriage are intact.  If cards are getting stuck in the middle carriage, the plastic tabs have most likely been damaged or have fallen off.  The below pictures show a middle carriage with no tabs(left) and with tabs(right).

 


To open the middle carriage, unscrew the four screws on the top.

  • No labels