Table of Contents
Equipment Models
This document is valid for the following equipment models...
- C-5001 FasCard Reader
Assumptions
This document assumes the installer has already configured a machine type via the FasCard administration website. For more information see 'Configuring Machine Types'
Tools Required
- No tools are required
Instructions
Access 'Set Address' Mode with Power Up Method
FasCard readers can be addressed during their initial start up routine.
- Connect power to FasCard reader
- Immediately after the card reader version appears, press an hold all three buttons for a moment.
- Manager menu appears
- Navigate to Maintenance menu and press - key
Access 'Set Address' Mode with Machine Admin Card
FasCard readers can be addressed anytime with a FasCard with the appropriate privileges asigned.
- Swipe FasCard with Machine Admin privleges
- Menu Appears
- Using arrows on keypad highlight 'Maintenance Menu' and press the - key
Setting Address
- The 'Change Machine#' option should be highlighted, press the - key
- Set Machine Number appears with 3 digits appearing the first one blinking
- Use the up and down arrows to change the flashing digit to the desired value
- Use the - key to confirm selection and move to the next digit
- Once all three digits have the desired values, the newly set number will be displayed and 'Confirm' will be flashing
- Press - to confirm
- Press any other key to display 'Retry', press - to re-enter address