The Talos Bill Note Acceptor (BNA) By Crane Payment Innovations (CPI) is the latest in a line of Bill Note Acceptor models to be used with CCI's X-Changer Cabinets and FasCard Kiosks. This detailed page discusses its properties, configuration, and installation of the device. |
As with the MEI Legacy 2000 BNAs, the Talos BNA connects using the same two ports on the side of the bill acceptor.
With native functionality for both v2 LaundryCard X-Changers and Touch Kiosks,
Although the Talos BNA works natively out-of-the-box, a coupon booklet may be needed (T2700 Models(link)-- T6 / T8 Models(link)) in the event that any configuration is lost over time.
All Talos BNAs out-of-the-box are pre-programmed under Mode 0 (High Acceptance) by default. Any modes above Mode 0 introduce stricter security features (i.e. High Security) and should only be used when necessary. |
Refer to the below chart to determine the issue.
# Of Flashes | Status | Recommended Solution |
---|---|---|
None | No Power | Restore power to BNA or machine. |
1 or 4 | Bill Path Blocked | Check for jams. Remove bill magazine and review bill path, cross channel, lower housing assembly, and inspect the unit. |
2 | Disabled From System (idle) | Ensure the unit has been enabled, checking both hardware/connectivity and software, if necessary. |
3 | Lower Housing Assembly Issue | Check that lower housing assembly is seated. ensure bill path is clean. |
5 | Magazine/Stacker Removed | Reattach magazine. |
Continuous Fast | Magazine/Stacker Full | Empty magazine and reattach. |
Continuous Slow | Unit Failure | Replace unit. |
Disconnect any electrical device from power before performing any work on the device. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or any damage that may occur to target equipment. Technical Support recommends using all appropriate safety equipment (such as hand and eye protection) during execution of the instructions below. |
Installing the Talos BNA aligns directly with its predecessor in clearance and mounting placement, with minor exceptions in connectivity.