This page is intended to guide the installer on the steps involved for a C-6204 power harness for Alliance ACA machines. This guide is meant to cover the installation processes for F1 and F2 readers. 

Required parts

Step-by-step guide

This harness is designed only to be used with the 12vDC accessory connections (H10) found on Alliance ACA control boards. Do not connect to any other connections, or modify harness to connect to an alternate power source.

  1. Locate the H10 connection on the ACA control board. 

    Example of an ACA control board. Position of the H10 connector may differ based on form factor.

  2. Plug in the (a.) 12vDC Harness Connector into the H10 connection.

    (a.) 12vDC Power Connector

  3. Locate a nearby Chassis Ground Screw. Connect the (b.) Ground Harness Connector to the Chassis Ground Screw.

    (b.) Chassis Ground

  4. Run the (c.) FasCard Power Connector to the FasCard reader mount.

    (c.) FasCard Power Connector

    This may differ between ACA models. Please be sure to route around any potential components that may damage the harness.


  5. Connect the (c.) FasCard Power Connector to the Power Harness Connection Port.

    F1 power harness connectorF2 power harness connector

Related documentation