_1191

Owned by David Bussman
Last updated: Dec 06, 2024
2 min read
 I-X0050

Part #: C-0110-TOP-144

Desc 1: Machine Start Harness

Desc 2: 144" - Alliance Pre-ACA

   Qty: 1

Part #: C-5033

Desc 1: Label

Desc 2: 4-5/8" x 3-1/2"

   Qty: 1

Part #: C-0110-CP

Desc 1: Jumper Plug

Desc 2: Enables card mode on pre-ACA

   Qty: 1

Part #: C-6411

Desc 1: F3, MLV Stack Add On Dongle

Desc 2: Serial / MultiVend

   Qty: 1

Part #: C-0940

Desc 1: Vault Cover

Desc 2: 3-7/8" x 2-3/4"

   Qty: 1

The following steps assume the start harness for the upper pocket control is already connected.

  1. Run C-0110-TOP-144 Machine Start Harness to the lower pocket Machine Control Assembly.

  2. Pulse Setup

    1. Connect the C-0110-TOP-144 Machine Start Harness to the H3 connection on the Machine Control Assembly.

    2. C-0110-CP Jumper Plug is not used, but can be retained in case of future serial communication usage usage.

    Serial Setup

    1. Connect the C-0110-TOP-144 Machine Start Harness to the H3 connection on the Machine Control Assembly.

    2. Connect the C-0110-CP Jumper Plug to the H6 connection on the Machine Control Assembly.

  3. Locate area to mount C-6411 Serial Stack Add-On Dongle.

    1. Must be close enough to reader mounting location to connect the harness to.

    2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)

  4. Clean mounting location to remove any dust and residue if needed.

  5. Remove the sticker from the back of the C-6411 Serial Stack Add-On Dongle to expose the adhesive and apply to the mounting location.

  6. Connect the C-6411 Stack Add-on Dongle to port 5 (Serial Connection Port) on the card reader.

    1. Connect the C-0110-TOP Machine Start Harness connected to the upper pocket Machine Control Assembly to Unit 1 on the Stack Add-on Dongle.

    2. Connect the C-0110-TOP-144 Machine Start Harness connected to the lower pocket Machine Control Assembly to Unit 2 on the Stack Add-on Dongle.

  7. Bend the side tabs of the C-0940 Vault Bracket outward and install into the coin vault for the lower pocket. The tabs should snap into place securing the bracket.

  8. Apply the C-5033 Label over the opening for the lower pocket’s coin drop.