The following steps assume the start and coin sense harnesses are already connected to the upper pocket control.

Locate area to mount C-6410 Pulse Stack Add-On Board.
1. Must be close enough to reader mounting location to connect the harness to.
2. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)
Clean mounting location to remove any dust and residue if needed.
Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location.
Connect the white, 6-pin connector from the C-5300-NC-144 Machine Start Harness to the J1 connection on the C-6410 Pulse Stack Add-On Board.
Connect the white, 3-pin connector from the C-5300-NC-144 to the Coin 1 connection on the lower pocket's Machine Control Assembly.
Take the C-0940 Vault Cover and bend the inner tabs outward.
Insert the C-0940 Vault Cover into the coin box opening for the lower pocket’s control. The previously bent tabs should catch the inner lip of the coin vault and secure the bracket in place.
Optional: Apply C-5033 Label over the coin drop opening for the lower pocket control.

Browser not supported