3659 LaundryCard Reader Install Guide

Owned by David Bussman
Last updated: Jan 24, 2024 by Chris Kite
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Top Load Washer
Manufacturer: Wascomat
Make: Encore
Model Length: 9 to 11

Coin models and card models both use the metercase and can use the same card only installation kit.

Associated Models


WMTW4371C2FMI
WMTW4371M
WMTW4371MC2
WMTW4371MCWDC

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Install Mounting Hardware

 I-M0194

Part #: C-6912

Desc 1: F2 Metercase Bracket

Desc 2: Encore - Grey

   Qty: 1

Part #: C-1059

Desc 1: Nut

Desc 2: 10-32 - Kep

   Qty: 2

Part #: C-5420

Desc 1: Screw

Desc 2: 10-32 x ¼" - Pan

   Qty: 2

Part #: C-5416

Desc 1: Screw

Desc 2: 8-32" x 3/8" - Button - Torx

   Qty: 2

Part #: C-5414

Desc 1: F2 Standard Mounting Bracket

Desc 2: Sheet metal base

   Qty: 1

  1. Remove existing coin drop and coin box from the metercase.

  2. Install the C-0942 Metercase Bracket into the front of the metercase using the (2) C-1059 10-32 Keps Nuts.

  3. Run the Cat5 cables and C-5355 Machine Start Harness through the metercase and then through the rectangular opening in the C-0942 Metercase Bracket.

Connect Machine Interface Harness

 I-T0062

Part #: C-5355

Desc 1: Machine Start Harness

Desc 2: Crossover

   Qty: 1

  1. Connect the C-5355 Machine Start Harness to the CN4 Payment Device Connection located inside the metercase.

Connect and Mount Reader

  1. Connect the free end of the C-5355 Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.

  2. Connect the the Cat5 cables running to and from the adjacent machines to ports labeled 3 (Line Connection Ports) as shown in the image above.

  3. Insert the reader into the C-0942 Metercase Bracket and secure using the (2) C-0141 8-32 x 1-1/2" Cap Screws and then cover using the C-0015 Label.

Machine Configuration

CCI Software Configuration

Machine ControlPulseSerial
EncoreSingleVend (MLV+) / 75Laundrylux Crossover Encore

Additional Resources