0435 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Washer
Manufacturer: Whirlpool
Make: Whirlpool
Model Length: Not Set

Associated Models


CAM2752RQ0
CAM2752TQ
CAM2752TQ2
CAM2752TQ3
CAM2762RQ0
CAM2762TQ
CAM2762TQ0
CAM2762TQ2
CAM2762TQ3

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Connect Power

 I-P0003

Part #: C-5101

Desc 1: Spade Taps

Desc 2: 18-14 AWG

   Qty: 3

Part #: C-5210

Desc 1: Power Adapter Harness

Desc 2: CGI

   Qty: 1

Part #: C-5500

Desc 1: Power Extension Harness

Desc 2: 25.5"

   Qty: 1

Part #: C-5602R1

Desc 1: Power Converter

Desc 2: SMT-012-018VW

   Qty: 1

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

  2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.

  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Machine Interface Harness

 I-T0021

Part #: C-0116-MEC

Desc 1: Machine Start Harness

Desc 2: Mechanical Harness

   Qty: 1

E-Z Wiring Harness

  1. Connect the C-0116-MEC Machine Start Harness to the E-Z Wiring Harness connection on the machine control assembly.

Other

  1. Connect the C-0116-MEC Machine Start Harness 6-pin connector at the Coin Box area.

    1. Connect the 2-pin connector of the harness under the faceplate, near display/controls.

CCI Software Configuration

Machine ControlPulseSerial

Additional Resources