3138 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Top Load Washer
Manufacturer: Alliance
Make: [VARIES]
Model Length: Not Set

Mechanical Timer equipped models are not supported.

Associated Models


BWTT20WN
HWT110WC
HWT120WC
HWT120WM
HWT911WN
HWT9201N
HWT920WN
HWTT20QM
HWTT20QN
HWTT20WN
JWT920WN
SWL521WN
SWLY20WN
SWT1211A
SWT121QN
SWT121WN
SWT220WN
SWT221QN
SWT221WN
SWT5211A
SWT521LA
SWT910WN
SWT920WN
SWT921QN
SWT921WN
SWTB21QM
SWTB21WN
SWTBA1QN
SWTJ21WM
SWTJ21WN
SWTT201N
SWTT20WN
SWTT21WN
SWTW20WN
SWTX21WN

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Connect Power

 I-P0003

Part #: C-5101

Desc 1: Spade Taps

Desc 2: 18-14 AWG

   Qty: 3

Part #: C-5210

Desc 1: Power Adapter Harness

Desc 2: CGI

   Qty: 1

Part #: C-5500

Desc 1: Power Extension Harness

Desc 2: 25.5"

   Qty: 1

Part #: C-5602R1

Desc 1: Power Converter

Desc 2: SMT-012-018VW

   Qty: 1

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

  2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.

  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Machine Configuration

CCI Software Configuration

Machine ControlPulseSerial
Coin Slide - Mechanical Timer*NOT SUPPORTED**NOT SUPPORTED*
Coin Slide Hybrid (Pulse)SingleVend (Relay) / 80ms*NOT SUPPORTED*
EDCSingleVend (Relay) / 80ms*NOT SUPPORTED*
MDC (Vended)SingleVend (MLV+) / 80msAlliance MDC Top Load Washer
NetMasterSingleVend (Relay) / 80ms*NOT SUPPORTED*
Nonmetered*NOT SUPPORTED**NOT SUPPORTED*

Additional Resources