3294 Reader Install Guide
- Chris Kite
- CCI Integration User
Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Washer
Manufacturer: Continental
Make: Continental
Model Length: 12
L-Series Hard-Mount Washers
Associated Models
L1018CM21310
L1018CR21510
L1030CM11310
L1030CM21310
L1030CR21510
L1040CM11310
L1040CM21310
L1040CR11510
L1040CR21310
L1040CR21510
L1050CM11310
L1050CM21310
L1075CM11111
L1075CM21010
L1075CM21310
L1075CM21313
L1075CM21320
L1075CR11111
L1075CR21510
L1125CM13200
L1125CM21300
L1125CM21310
L1125CM21320
L1125CM21329
L1125CM23000
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Part #: C-6334
Desc 1: Combination Harness
Desc 2: CGI CM
Qty: 1
Disconnect the existing wires from the Coin Drop and connect the C-6334 Combination Coin/Start Harness to the Coin Drop.
Blue wires go to common (Co) and normally open (NO) on coin switch.
Part #: C-6334
Desc 1: Combination Harness
Desc 2: CGI CM
Qty: 1
Disconnect the existing wires from the Coin Drop.
Connect the C-6334 Machine Start Harness to the Coin Drop.
Connect the Violet wires to Blue wires 36 & 35.
White wires wrapped with Violet go to Red wires 207 & 30.
White wires wrapped with Blue go to Brown coin blocking solenoid wires.
Wrap the connectors in electrical tape to keep the bare terminals from exposing.