3334 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Washer Extractor
Manufacturer: Alliance
Make: Speed Queen
Model Length: Not Set

Associated Models


HC20MD2OU2
SC27MD2YU4
SC50MD3BU4
SC60BX2OU6

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

CCI Software Configuration

Machine ControlPulseSerial
EDCSingleVend (Relay) / 80ms*NOT SUPPORTED*
NetMasterSingleVend (Relay) / 80ms*NOT SUPPORTED*
P-ComputerSingleVend (Relay) / 80ms*NOT SUPPORTED*
S-ComputerSingleVend (Relay) / 80ms*NOT SUPPORTED*
Single/Dual CoinSingleVend (Relay) / 80ms*NOT SUPPORTED*
V-ComputerSingleVend (Relay) / 80ms*NOT SUPPORTED*

Additional Resources