3631 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Stack Washer/Dryer
Manufacturer: Alliance
Make: [VARIES]
Model Length: 18

Stack washer / dryer. Requires two kits. One for dryer and one for washer portion.

Associated Models

HST030NVCAXS1YE000
HST030NVX0XS3YE000
HST050NVCAXS1YE000
SST030NVCAXS1YE000
SST030NVCAXS3YE000
SST030NVL0XS2YE000
SST030NVX0XS3YE000
SST050LVY0XS1YE00E
SST050NVCAXS1YE000
SST050NVCAXS3YE000
SST050NVX0XS2YE000
SST050NVX0XS3YE000

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Connect Power

I-P0002

Part #: C-6204-40

Desc 1: Power Adapter Harness

Desc 2: F2, 12vDC Pow Harness - 40"

Qty: 1

Connect the C-6204-40 12VDC Power Harness to the H10 connection on the Machine Control Assembly.
Connect the green wire to a chassis ground.
The remaining end (3-pin molex) connects directly to the rear of the FasCard Reader.

Connect Machine Interface Harness

I-T0003

Part #: C-5240

Desc 1: Machine Start Harness

Desc 2: Alliance ACA