3663 Reader Install Guide

Owned by Chris Kite
Last updated: Jan 26, 2024 by CCI Integration User

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Small Dryer (Single)
Manufacturer: Wascomat
Make: Encore
Model Length: 11 to 10

Associated Models


DLHF0315EC2DC
DLHF0315EC2FMI
DLHF0315EDC
DLHF0315EM
DLHF0315EOPL
DLHF0315GC2DC
DLHF0315GC2FMI
DLHF0315GDC
DLHF0817E
DLHF0817EDC
DLHF0817G
DLHF0817GM
DLHS0315EC2FMI
DLHS0315GC2FMI

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Connect Power

 I-P0016

Part #: C-5350

Desc 1: Power Adapter Harness

Desc 2: Crossover

   Qty: 1

  1. Connect the C-5350 Power Adapter Harness to the 2-pin power connector bundled with the CN4 serial communication harness connection near the payment device opening inside the machine.

  2. Secure the green ground wire under a machine chassis screw.

Instructions do not exist for Kit I-P0030

Connect Coin Sense Harness

 I-S0042

Part #: C-6352-40

Desc 1: Coin Sense Harness

Desc 2: 40"

   Qty: 1

  1. Disconnect the Coin Drop from the Machine Control Assembly.

  2. Connect the C-6352-40 Coin Sense Harness to the harness connected to the Coin 1 machine harness.

Connect Machine Interface Harness

 I-T0062

Part #: C-5355

Desc 1: Machine Start Harness

Desc 2: Crossover

   Qty: 1

  1. Connect the C-5355 Machine Start Harness to the CN4 Payment Device Connection on the Machine Control Assembly
    NOTE: On top-load machines, the CN4 connection is located inside the metercase.

CCI Software Configuration

Machine ControlPulseSerial
EncoreSingleVend (MLV+) / 75ms*NOT SUPPORTED*

Additional Resources