3697 Reader Install Guide
- David Bussman
Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Tumble Dryer (Single)
Manufacturer: ONNERA Group
Make: [VARIES]
Model Length: Not Set
Associated Models
UDTT25G
UDTT80G
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Connect Machine Interface Harness
Part #: C-5374R1
Desc 1: FC-LC Start Harness
Desc 2: Pulse Start Harness
Qty: 1
If coin drop is present, disconnect the coin drop from the extension harness for the CN8 connection and connect the C-5374R1 Pulse Start Harness to the 6-pin connector on the extension harness.
