The following steps assume a start harness is already connected to the upper pocket control.

Attach the C-5313 Terminal Block to the Machine Control Assembly for the lower pocket.
Run the C-5356-144 Machine Start Harness to the lower pocket Machine Control Assembly.
Connect the C-5356-144 Machine Start Harness to Positions 2 and 3 on the C-5313 Terminal Block.
Connect the C-6400 Stack Add-on Board to port 5 (Serial Connection Port) on the card reader.
Connect the white, 6-pin connector from the C-5356-144 Machine Start Harness to the J1 connection on the C-6400 Stack Add-On Board.
Insert the C-0941 Vault Cover into the coin vault for the lower pocket’s control.
Install the C-0907 Coin Drop Cover using the (4) C-0136 4-40 1/2” Pan Screws and (4) C-1062 4-40 Kep Nuts to secure in place.

Browser not supported