_Reader Installation

Owned by Chris Kite
Last updated: Mar 13, 2024
2 min read

Overview

This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below.

Install Header

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

F1 Reader Ports

F2 Reader Ports

 

Item No.

Component

Notes

1

Power Connection Port

Utilizes the same power harnesses as the first generation FasCard reader.

2

Pulse Connection Port

Connection point for pulse machine start harnesses.

3

Coin 1 Connection Port

This is the connection point for the harness input associated with Coin 1.

4

Coin 2 Connection Port

This is the connection point for the harness input associated with Coin 2.

5

Serial Connection Port

This is the connection point for serial machine start harnesses.

Unverified

These instructions and kit hardware have not been verified or tested by Card Concepts Inc. and are used at the installers own risk.

Additional Resources

Additional Resources

ACA Dip Switches

ACA machines using a serial configuration require dip switch 3 on the Machine Control Board to be set to the 'ON' position. Leave all other dip switches as is.

Tools

  • Champion CT7-1-1/8 Tungsten Carbide Tipped
    1-1/8-Inch Hole Cutter-1-Inch Thick Metal
    (Or Equivalent)

  • Cutting Oil

  • 9/64" Drill Bit (Optional)
    If drilling stainless steel should be rated for 
    such
    (Or Equivalent)

  • Heavy Duty Professional 3/8" Magnesium Drill
    with #2 drill tip extension.
    (Or Equivalent)

  • Center Punch
    (Or Equivalent)

  • Hammer

  • Fine Point Sharpie Marker (or equivalent)

  • Pliers (or equivalent)

  • Tape Measure

ACA Card Reader

ACA Card Ready machines using a pulse configuration require a retrofit to a Coin-Ready state. This may require obtaining an additional Coin Sense Harness from Alliance.

Â