Run C-0110-TOP-144 Machine Start Harness to the lower pocket Machine Control Assembly.
Pulse Setup
1. Connect the C-0110-TOP-144 Machine Start Harness to the H5 connection on the Machine Control Assembly.
2. C-0110-CP Jumper Plug is not used, but can be retained in case of future serial communication usage usage.
Serial Setup
1. Connect the C-0110-TOP-144 Machine Start Harness to the H5 connection on the Machine Control Assembly.
2. Connect the C-0110-CP Jumper Plug to the H2 connection on the Machine Control Assembly.
Connect the C-6401 Stack Add-on Board to port 5 (Serial Connection Port) on the reader.
1. Connect the Machine Start Harness connected to the upper pocket Machine Control Assembly to Unit 1 on the Stack Add-on Board.
2. Connect the Machine Start Harness connected to the lower pocket Machine Control Assembly to Unit 2 on the Stack Add-on Board.
Bend the side tabs of the C-0940 Vault Bracket outward and install into the coin vault for the lower pocket. The tabs should snap into place securing the bracket.
Apply the C-5033 Label over the opening for the lower pocket’s coin drop.

Browser not supported