3660 Reader Install Guide
- David Bussman
- CCI Integration User
- Chris Kite
- Adam Arafat
Warning!
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.
It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Overview
Equipment Details
Type: Small Dryer (Single)
Manufacturer: Whirlpool
Make: Whirlpool
Model Length: 10
Associated Models
CED9050AWO
CGD9050AW0
CGD9050AW1
Recommended Tools and Supplies
Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure
Installation
Connect Power
Part #: C-5101
Desc 1: Spade Taps
Desc 2: 18-14 AWG
Qty: 2
Part #: C-5336
Desc 1: Power Adapter Harness
Desc 2: Dexter Stack
Qty: 1
Part #: C-5500
Desc 1: Power Extension Harness
Desc 2: 25.5"
Qty: 1
Part #: C-5602R1
Desc 1: Power Converter
Desc 2: SMT-012-018VW
Qty: 1
Tap power as described in the FasCard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
120vac: Connect the blue wire to L1 and the brown wire to N.
240vac: Connect the blue wire to L1 and the brown wire to L2.
Secure the green wire to the ground screw.
Connect the C-5336 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
Extras
No EXTRAS kits exist for this equipment.
Machine Configuration
Enter Service Mode and navigate to J option.
Set option to J.d.
Exit Service Mode.
CCI Software Configuration
| Machine Control | Pulse | Serial |
|---|---|---|
| Gen1 | SingleVend (MLV+) / 24ms | *NOT SUPPORTED* |
Additional Resources
- How to Program Address on a FasCard Reader
- FasCard Admin Site - Equipment Setup
- FasCard Admin Site - Machine Setup
- FasCard Admin Site - Pricing & Features Schedule
- F1 Reader Mounting Guide
- FasCard F2/F3 Reader Installation Guide - Front Mount
- FasCard Installation Videos
- FasCard Kit Installations - Machine Configurations & Related Documents