Master Excerpt List
- Steve Marcionetti
- Christopher Patac
- Former user (Deleted)
Tools and supplies
Description | Link/Source |
|---|---|
Champion CT7-1-1/8 Tungsten Carbide Tipped | |
9-64" Drill Bit | |
Cutting Oil | |
Heavy Duty Professional 3-8" Magnesium Drill | |
Right Angle Drill Attachment | |
Center Punch | |
Hammer | |
Pliers | |
No.2 Phillips Screwdriver | |
3-32" Head Allen Hex Screwdriver | |
Fine Point Sharpie Marker | |
Tape Measure | |
Cable Ties | |
Electrical Tape | |
FasCard Drill Template | CCI |
Tools and supplies
Description | Link/Source |
|---|---|
Champion CT7-1-1/8 Tungsten Carbide Tipped | |
9/64" Drill Bit | |
Cutting Oil | |
Heavy Duty Professional 3/8" Magnesium Drill | |
Right Angle Drill Attachment | |
Center Punch | |
Hammer | |
Pliers | |
No.2 Phillips Screwdriver | |
3-32" Head Allen Hex Screwdriver | |
Fine Point Sharpie Marker | |
Tape Measure | |
Cable Ties | |
Electrical Tape |
Assumptions
This document assumes the installer has a working knowledge of hand tools and of the target machine in question. It is recommended that instructions herein be performed by individuals who are qualified to perform these tasks. CCI takes no responsibility for the accuracy of this document, or for any damage that may occur to the target machine.
This document assumes the following items have been acquired and are not a part of the installation kit.
Install Guide
Caution
Always make sure that the power is turned off to the target machine before starting installation.
It is recommended that the instructions contained herein be performed by individuals qualified to perform these tasks.
Always take precautions to protect your eyes and hands when performing an installation.
Images shown
Images in this document may not match the exact machine for which the instructions are designed and are used to help describe procedures
Card Reader Excerpts
