Page Comparison

1. Place theC-5700-TEMPDrill Template on the desired mounting location.

2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

3. Refer to for further instructions.

1. Remove the mounting bolt securing the coin drop to the metercase. Then remove the coin drop and coin box.

2. Run reader harnesses through the metercase and the hole on the C-5771Metercase Bracket.

3. Install C-5771Metercase Bracketinto the metercase and secure using C-0301 Mounting Bolt.

1. Locate the incoming power cables in the rear of the machine. This should include a white, black and green wire.
   

2. Use the C-5101 Spade Tapsto tap the black (L1) and white (Neutral) wires.
   
3. Attach the spade ends of the C-5336 Power Adapter Harnessto the taps. Blue to black, and Brown to White.
   
4. Attach the Green ground wire from the C-5336 Power Adapter Harnessto a nearby chassis ground screw.
   
5. Connect the 3-pin connector from the C-5336 Power Adapter Harness to the 3-pin connector on the C-5602R1 Power Converter.
   
6. Connect the 4-pin connector from the C-5602R1 Power Converter to the 4-pin connector on the C-5500Power Extension Harness.
   
7. Mount the C-5602R1Power Converterin the machine by using zip ties to secure it to the machine's wire harness.
   

1. Disconnect the Coin Drop from the Machine Control Assembly.
2. Connect theC-5362 Coin Sense Harness to the harness connected to the Coin Drop.

Connect theC-5364Machine Start Harness to theAA3 connector on the Machine Control Assembly.