Versions Compared

Old Version 3

changes.mady.by.user Adam Arafat

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID616
KitDescCoin and Card

  1. Place theC-5700-TEMPDrill Template on the desired mounting location.

  2. Verify that included harnesses will reach the desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Connect Power

Cci readerinstall kit
KitID617
KitDescTap Machine Power

  1. Tap power as described in the page by connecting the C-5213 Power Adapter Harness to the power distribution panel inside the machine.

    1. 120vac: Connect the brown and blue wires to L1 and N terminal connections.

    2. 240vac: Connect the brown and blue wires L1 and L2 terminal connections.

    3. Connect the green/yellow wire to the GND terminal connection.

  2. Connect the opposite end of the C-5213 Power Adapter Harness to the C-5602R1 Power Converter.

  3. Connect the C-5500-115 Power Extension Harness to the appropriate connector on the C-5602R1 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID679
KitDescFactory Optical Coin Drop
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect theC-5258 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID634
KitDescDryer - Pulse
  1. Connect theC-5254 Machine Start Harness to the Coinconnection on the Machine Control Assembly.
Cci readerinstall kit
KitID578
KitDescWasher - Serial
  1. Connect theC-0127-MLV Machine Start Harness to theP23connection on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF1 Reader
PageWithExcerpt_Reader Ports

  1. Feed the remaining harness ends through the mounting hole.
  2. (Dryer Pocket) Connect the free end of theC-5254 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. (Washer Pocket) Connect the free end of the C-0127-MLV Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
  4. (Coin and Card Installation Only) Connect the free end of the C-5258 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  5. Connect the free end of the C-5500-115 Power Extension Harness to port 4 (Power Harness Connection Port) as shown in the image above.
Cci readerinstall footer