Versions Compared

Version Old Version 2 New Version 3
Changes made by

Chris Kite

CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID841
KitDescCoin and Card

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID988
KitDescCard Only - Quantum Touch Control
  1. (Coin Model Only)Install theC-5365 Bypass Harnessby removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.

  2. Remove factory payment device bay cover or card reader mounting plate.

  3. Place the C-6976Quantum Touch Stk Dryer Mounting Bracketinto the payment device opening and secure using the(4) C-107310-24 Hex Nut.

  4. Align theC-5414F2 Mounting Bracketwith theC-6976Quantum Touch Stk Dryer Mounting Bracketand attach using the(2) C-5420 10-32 x 1/4" Screws.

Connect Power

Cci readerinstall kit
KitID581
KitDesc12VDC Accessory Power
  1. Connect theC-6204-4012VDC Power Harnessto the H10connection on the Machine Control Assembly.
    1. Connect the green wire to a chassis ground.
  2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID700
KitDescCoin Drop - Factory Optical
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect theC-6250 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID582
KitDescSerial Communication / Pulse
  1. Connect theC-5240 Machine Start Harness to theH3 connector on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of the C-5240 Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.
  3. (Coin and Card Installation Only) Connect the free end of the C-6250 Coin Sense Harnessto port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of the C-6204-40 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.

Machine Configuration

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameMidas
PageWithExcerpt_Machine Configuration

Cci readerinstall footer