Versions Compared

Old Version 2

changes.mady.by.user Chris Kite

Saved on

compared with

New Version 3

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID584
KitDescCoin and Card

  1. Place theC-6700-TEMPDrill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Connect Power

Cci readerinstall kit
KitID595
KitDescTap Machine Source Power
  1. Tap the machine AC power wires using theC-5101Spade Taps.
    1. For120vmodels:L1,N, andGroundwires
    2. For240vmodels:L1,L2, andGroundwires
  2. Connect the three wires from the C-5210 Power Adapter Harnessto theC-5101 Spade Taps.
    1. Connect theBluewire to the L1tap.
    2. Connect the Brownwire to the N/L2tap.
    3. Connect theGreen/Yellowwire to the Groundtap.
  3. Connect the 3-pinconnector from the C-5210 Power Adapter Harnessto the matching connector on the C-5602R1 Power Converter.
  4. Connect the 4-pinconnector from theC-5602R1 Power Converterto the matching connector on theC-5500Power Extension Harness.
  5. Run the C-5500Power Extension Harness to the reader mounting location.

Connect Coin Sense Harness

Cci readerinstall kit
KitID884
KitDescFactory - Optical Coin Drop - Coin Sense Portion of Combination Harness
  1. Disconnect the coin sensor from Terminal Board C.
  2. Connect the wires from the coin sensor to the three circuit screw down terminal with the blue, green, and red wires.
    1. Pair the harness wires to the same colored wires from the coin sensor.
  3. Disconnect the wires from the door switch and connect the white wires with female spade terminal connectors to the same locations.

Connect Machine Interface Harness

Cci readerinstall kit
KitID884
KitDescFactory - Optical Coin Drop - Start Pulse Portion of Combination Harness
  1. Connect the wires from the Terminal Board C to the three circuit screw down terminal with the blue, green, and black wires.
    1. Pair the machine wires to the the following screw down terminal wires:
      1. Blue wire to blue.
      2. Green wire to green.
      3. Red wire to black.
  2. Take the wires previously connected to the door switch and connect the white wires with male spade terminal connectors to the wires.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the larger, white 6-pin connector of the C-6310 Combination Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. (Coin and Card Installation Only) Connect the smaller, white 5-pin connector of the C-6310 Combination Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.
Cci readerinstall footer