3682 Reader Install Guide

Install Mounting Hardware

 I-M0003

Part #: C-6801

Desc 1: F2/F3 Reader Mounting Kit

Desc 2: Universal

   Qty: 1

1. Place the C-6700-TEMP Drill Template on the desired mounting location.

2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

3. Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.

Connect Power

 I-P0003

Part #: C-5101

Desc 1: Spade Taps

Desc 2: 18-14 AWG

   Qty: 3

Part #: C-5210

Desc 1: Power Adapter Harness

Desc 2: CGI

   Qty: 1

Part #: C-5500

Desc 1: Power Extension Harness

Desc 2: 25.5"

   Qty: 1

Part #: C-5602R1

Desc 1: Power Converter

Desc 2: SMT-012-018VW

   Qty: 1

1. Tap the machine AC power wires using the C-5101 Spade Taps.
   1. For 120v models: L1, N, and Ground wires
   2. For 240v models: L1, L2, and Ground wires
2. Connect the three wires from the C-5210 Power Adapter Harness to the C-5101 Spade Taps.
   1. Connect the Blue wire to the L1 tap.
   2. Connect the Brown wire to the N/L2 tap.
   3. Connect the Green/Yellow wire to the Ground tap.
3. Connect the 3-pin connector from the C-5210 Power Adapter Harness to the matching connector on the C-5602R1 Power Converter.
4. Connect the 4-pin connector from the C-5602R1 Power Converter to the matching connector on the C-5500 Power Extension Harness.
5. Run the C-5500 Power Extension Harness to the reader mounting location.

Connect Coin Sense Harness

 I-C0011

Part #: C-6310

Desc 1: Combination Harness

Desc 2: Gen Pulse Sense Eye

   Qty: 1

1. Disconnect the coin sensor from Terminal Board C.
2. Connect the wires from the coin sensor to the three circuit screw down terminal with the blue, green, and red wires.
   1. Pair the harness wires to the same colored wires from the coin sensor.
3. Disconnect the wires from the door switch and connect the white wires with female spade terminal connectors to the same locations.

Connect Machine Interface Harness

 I-C0011

Part #: C-6310

Desc 1: Combination Harness

Desc 2: Gen Pulse Sense Eye

   Qty: 1

1. Connect the wires from the Terminal Board C to the three circuit screw down terminal with the blue, green, and black wires.
   1. Pair the machine wires to the the following screw down terminal wires:
      1. Blue wire to blue.
      2. Green wire to green.
      3. Red wire to black.
2. Take the wires previously connected to the door switch and connect the white wires with male spade terminal connectors to the wires.

Connect and Mount Reader

1. Feed remaining harness ends through the mounting hole.
2. Connect the larger, white 6-pin connector of the C-6310 Combination Harness to port 2 (Pulse Connection Port) as shown in the image above.
3. (Coin and Card Installation Only) Connect the smaller, white 5-pin connector of the C-6310 Combination Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.