Versions Compared

Old Version 5

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version 6

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID917
KitDescCoin and Card

  1. Place the C-5700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to F1 Reader Mounting Guide for further instructions

.
Cci readerinstall kit
KitID828
KitDescCard Only - Coin Model
Remove the mounting bolt securing the coin drop to the metercase. Then remove the coin drop and coin box

  1. .

Run reader harnesses through the metercase and the hole on the C-5771Metercase Bracket.Install C-5771Metercase Bracketinto the metercase and secure using C-0301 Mounting Bolt.

Connect Power

Cci readerinstall kit
KitID663
KitDescTap Machine Power

  1. Locate the incoming power cables in the rear of the machine. This should include a white, black and green wire.

  2. Use the C-5101 Spade Taps to tap the black (L1) and white (Neutral) wires.

  3. Attach the spade ends of the C-5336 Power Adapter Harness to the taps. Blue to black, and Brown to White.

  4. Attach the Green ground wire from the C-5336 Power Adapter Harness to a nearby chassis ground screw.

  5. Connect the 3-pin connector from the C-5336 Power Adapter Harness to the 3-pin connector on the C-5602R1 Power Converter.

  6. Connect the 4-pin connector from the C-5602R1 Power Converter to the 4-pin connector on the C-5500 Power Extension Harness.

  7. Mount the C-5602R1Power Converter in the machine by using zip ties to secure it to the machine's wire harness.

Connect Coin Sense Harness

Cci readerinstall kit
KitID693
KitDescFactory - Optical Coin Drop

  1. Disconnect the Coin Drop from the Machine Control Assembly.

  2. Connect the C-5362 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID590
KitDescPulse - AA3 / Debit Connection

Connect the C-5364Machine Start Harness to the AA3 connector on the Machine Control Assembly.

Connect and Mount Reader

...

.

...

Machine Configuration

  1. Enter Service Mode and navigate to J option.

  2. Set option to J.d.

  3. Exit Service Mode.

...